MULTIMAC C 90º Feeding & Collation

Features:

• Two single wound films are placed on to the upper and lower side film carriage rollers
• Top and bottom motorized film drive and relevant film advance balancer attachments
• 90ºInfeed belt for automatic infeed
• Max seal bar height: 400mm
• Advantage of making group sets with the benefit of 90º infeed belt
• Pneumatic pusher with side guides for package infeed/li>
• Automatic discharge belt until heat tunnel
• Constant sealer to give two seals with a center cut fitted with a cartridge heater
• Digital temperature controller for consistent seal with a thermocouple control
• Pneumatic cylinder and double heavy duty linear bearings for accurate motion
• Easy to change rubber and Teflon set on the bottom jaw
• PLC programmed software for customized inquiries and flexibility
• Detection sensor against package or hand entrapment
• Optional holder to keep the package steady during sealing by soft vertical cylinder
• Max. height adjustment for the jaw
• Smooth product transfer through the tunnel conveyor.
• Speed controller for conveyor and heat adjustment for powerful shrinkage at PE films
• Secondary and emergency heat controller for safety regulation in shrink tunnel
• Air flow control flaps with handle for shrink tunnel
• Post cooling switch to cool down to 70ºC before switch off
• Silicon coated tunnel conveyor bars for perfect heat insulation